Follow these easy steps to get your Electrolux Z 25/4 W Refrigerator up and running in no time.
Remove all securing tapes. Wash the inside of the appliance with a solution of lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly.
The temperature inside the refrigerator is regulated by a thermostat with 6 positions and an 'OFF' position. Position 1 is minimum coldness and Position 6 is maximum coldness. Turn the thermostat dial to the required position, typically the intermediate position (3-4) is most suitable.
This appliance should be located in a dry atmosphere, out of direct sunlight, and away from extreme temperatures. Adjust the level of the appliance by screwing out the adjustable feet at the bottom of the cabinet using your fingers.
Install the spacers provided into the special holes at the back of the appliance. Ensure the arrow (A) is positioned correctly as shown in the diagram provided in the manual.
Ensure the appliance is plugged into a power supply of 220-240 V / 50 Hz. Do not use extension cords or adapters.
If you wish to reverse the door opening direction, refer to the specific instructions under 'Door Reversal' in the manual.
The appliance should be left for 2 hours after installation before it is turned on to allow the refrigerant to settle.